Copyright 2011 MMB Research Inc. All Rights Reserved Somfy Glydea Zigbee Motor Control4 Composer Driver Compatible Minimum Zigbee Firmware Version 1.2.0 ============= Button Press ============= * Press and Hold the Push Button for more than 5 seconds -- If the device is joined to a network, this button press action will trigger the somfy motor zigbee module to leave its current network. -- Once the device is in the network down state, this button press action will trigger the somfy motor zigbee module to perform a new network search for 90 seconds. * Press and Release Push Button Immediately -- It will trigger the maunal operation of the motor. -- For each button press, the motor will cycle between the following actions - Move Up - Stop - Move Down - Stop * Press and Hold the Push Button during Power Up of the Motor -- It will trigger the somfy motor zigbee module to enter the factory reset process -- Release the push botton once the LED is blinking -- During the factory reset process, the somfy motor zigbee module will leave its current network. and perform a module reset before powering up again. -- The zigbee module will stay at network down state until the user Press and Hold the Push Button for 5 seconds. ============= LED Indication ============= * Power Up Trouble Shooting -- LED will be solid on for five seconds immediately after power up to indicate it has power * Factory Reset -- LED will blink for five seconds when the radio module is during the factory reset process * Zigbee Network Status -- LED Solid On when the somfy motor zigbee module is joined a network successfully -- LED Off when the somfy motor zigbee module is NOT joined to a network (network down state) ============= Supported Zigbee Features for Motor Operation ============= * Move Up * Move Down * Toggle * Stop (Move to My Position) * Set My Position ============= End of Documentation ============= Hold Push Button for 5 seconds and release to Identify the Somfy Motor. Debug Mode LIST Off Print Log Print and Log Off false MOTOR TYPE STRING SOMFY GLYDEA MOTOR true Firmware Version STRING Unknown true Last Status STRING true Motor Position LIST Down Up Down false Set My Position ACT_SET_MY_POS Stop ACT_STOP Move Down ACT_MOVE_DOWN Move Up ACT_MOVE_UP Set My Position Set the current Motor Position as My Position. The Motor must be in Rest. Somfy Glydea Shade Devicedevices_sm/blinds.gifdevices_lg/blinds.giflua_genDriverWorks User Interface blind somfy:glydea 5001 6 Blind 2 False False False False BLIND 6001 6 ZIGBEE 4 True False False True ZIGBEE True False False 1 ON Event ON Event 2 OFF Event OFF Event 3 TOGGLE Event TOGGLE Event 4 STOP Event STOP Event SomfyMMB Research Inc11/15/2011 17:00 PM04/10/2012 15:00 PMSomfy Glydea Shade Device