Remember to power only one motor at a time and once programming is initiated make sure the screen is not inactive for more than two minutes or the motor will exit the programming mode. If that happens, start from the beginning.

Watch the video below for more information:

Programming Your Maestria 50 RTS

Let’s get started! To initiate programming, press and hold the up and down buttons simultaneously until the screen jogs. Check the direction of operation and if necessary change it by pressing and holding the “my” button until the screen jogs.

Position the screen at the desired upper limit and press “my” and down simultaneously. The screen lowers.

Next, position the screen at the desired lower limit. Maestria features ultra-precise limit adjustment with incremental control, which allows to position the load bar exactly where preferred, providing perfect screen alignment and complete protection from insects and pests.

Press “my” and up together, the screen rises.

Press MY to stop the screen and press My again until the screen jogs, validating the end limit settings.

As a final step, press and hold the programming button on the back of the control until the screen jogs. The motor is now in user mode.

Maestria is now set up and ready to be enjoyed! Thanks for watching!